Kool Roof
|
Premium White Elastomeric Roof Coating
|
|
DESCRIPTION:
Kool Roof
Bright White Elastomeric Coating is a premium grade, water-based,
acrylic elastomeric, “rubber-like” roof coating. Kool Roof is non-toxic,
non-hazardous, non-flmmable. When properly applied clean, dry, mechanically
sound roof Kool Roof will provide years of water-tight protection.
Kool Roof is easily applied with brush, roller or airless spray
equipment; it provides a highly protective barrier which will reflect
the damaging heat and destructive UV rays from the sun. High solar
reflectance can have a significant effect on reducing roof temperatures,
which can lead to a reduction of interior temperatures.
|
|
SURFACE PREPARATION:
All unnecessary and non-functional equipment must be removed from
the roof. The substrate must be pressure washed prior to the application
of Kool Roof.
A minimum working pressure of 1,500 psi should be used to remove
all dirt, dust and previous paints & coatings, which are delaminating.
Thoroughly rinse roof surface after cleaning. TSP (trisodium phosphate),
or appropriate cleaner, can be used along with a deck brush to clean
the roof, after which the roof must be thoroughly rinsed with clean
water. If the roof has an excess amount of oil or grease, a degreaser
may be required and scrubbing with a deck brush may be needed. Rusted
metal roofs must be wire brushed and primed with a metal primer/
sealer before Kool
Roof is applied.
|
|
APPLICATION:
First, make sure all repaired areas are sufficiently sealed and
dry and that the primer has been applied evenly. Any deficiencies
in the roof system must be corrected before proceeding. Choose the
morning of a warm day to apply the Kool Roof. Apply with a 3/4"
long nap exterior roller or medium bristle latex paint brush. Coating
is to be applied in two coats. Ideally, second coat should be applied
perpendicular to the first coat. Allow twenty-four hours between
coats. Humidity and temperature will vary dry time. On a cool humid
day, the dry time will be longer. Care should be used not to over
roll or brush coating on to roof surface. DO NOT apply to surfaces
with less than 1/2 inch per foot slope. DO NOT apply in a ponding
water area. DO NOT apply to any areas where ponding water exists.
This product can also be applied with airless spray equipment, 3,000
psi, 2 gpm with a .631 tip.
NOTE: If the roof becomes too hot (over 95F/ 35C) during application,
it is recommended to delay further application until the next morning
when surface temperatures are cooler. Excessive roof temperatures
may cause blistering of the coating.
|
| APPLICATION RATES: per coat
(three coats required for warranty) |
| Metal |
100 sq.ft./gal |
| Single-ply |
100 sq.ft./gal |
| Capsheet |
80 sq.ft./gal |
| Asphalt |
80 sq.ft./gal |
|
|
| COLOR TINTING : Universal
colorants can be used to tint coating to pastel and light colors.
Tint to coating ratio is not to exceed 4 ounces of colorant per gallon.
NOTE: Field tinting will void manufacturer's warranty. |
|
PRECAUTIONS:
Surface to be coated must be clean, dry and mechanically sound.
The roof must have positive drainage, NO PONDING WATER AREAS. Roof
surface temperatures must be between 50F - 90F (10C - 32C). DO NOT
apply if heavy fog, dew or rain is expected within 24 - 48 hours
of application. Do not applywithin4hoursofsunset. Lowtemperaturesandhumidity
will increase dry times. DO NOT allow liquid coating to freeze.
It is recommended that UV resistant sunglasses are used during application.
When transporting product, care should be taken to assure that the
lid is securely fastened to the bucket and that bucket is in an
upright position. DO NOT heat sealed container or store where temperatures
reach or exceed 120F (48C). Buckets are to be secured so that they
do not roll or tumble over, which may cause a leak or other damage.
Never transport full or partial buckets in vehicle where passengers
are present. Bucket shifting can cause bodily harm. Not recommended
for areas where foot traffic may occur.
|
| FIRST AID -KEEP OUT OF THE REACH
OF CHILDREN: If swallowed, do not induce vomiting. Seek medical
attention immediately. If contact with skin, wash with soap and water.
If contact with eyes, immediately flush eyes with clean water for
15 minutes. Seek medical attention if irritation persists. |
| STORAGE, CLEAN-UP and DISPOSAL:
Store unused product in its original, tightly sealed container.
Clean tools, hands and small spills with soap and water while wet.
Dispose of all containers in accordance with State and local governmental
regulations. |
| WARRANTY: This product is
warranted to be free of manufacturer's defects for 7 years when used
as part of the Kool Roof System and applied according to our written
specifications. If this coating does not perform as stated, Advanced
Coating Systems, Inc. will provide the original purchaser, with original
merchant sales receipt, replacement coating to repair the affected
part of the roof on a prorated basis and does not include labor, freight
or other materials mentioned or bearing the cost thereof. This warranty
does not cover ponding water or damage, acts of God or causes beyond
our control. Roof must have a minimum slope of 1" per foot to be eligible
for this warranty. Roof must be cleaned a minium once per year to
maintain this warranty. |
|
|
Damage resulting from causes beyond normal wear and tear
such as (i) unusual weather conditions or natural disasters, including,
but not limited to, storms, hail, floods, hurricanes, lightning, tornadoes,
and earthquakes; (ii) improper storage or handling of materials on the System;
(iii) excessive snow or ice movement; or (iv) fire. Acts of negligence,
abuse, accidents, vandalism, falling objects, civil disobedience, war or
any other acts beyond the control of ACS, including, but not limited to
plant or animal life. Owner's or the building occupant's failure to use
reasonable care in maintaining the roof. Conditions that prevent positive
drainage that results in ponding water on the roof are all beyond the scope
of this warranty.
Our suggested installation specification are based on information for laboratory
and field testing, which we believe to be reliable and correct; however,
accuracy and completeness of said tests are not guaranteed and not to be
construed as a warranty, either express or implied. Since the use of the
material is beyond the manufacturers control, buyer assumes all risks whatsoever
as to their use or results obtained. We guarantee our products to confirm
to Advanced Coating Systems, Inc. quality control. Advanced Coatings Systems,
Inc. warrants only the standard quality of material. Manufacturers sole
responsibility shall be to replace that portion of the product which is
proven to be defective.
Advanced Coating Systems, Inc. makes no other warranty of any kind whatsoever
expressed or implied as to the description, quality, merchantability or
fitness of any particular purpose and under no circumstances is manufacturer
responsible for incidental or consequential damages of any kind to the building
upon which the roof is affixed or its contents, loss of rent or profit or
any inconvenience. Neither seller nor manufacturer shall be liable of any
injury arising from the use of or inability to use the product. There is
no express warranties which extend beyond the description on the face there
of. Installer is responsible to check the adhesion and compatibility of
all Kool Roof products prior to application.
|
Kool Roof
|
PROPERTY |
RESULTS |
Weight Solids
ASTM D1644
|
57+ /1% |
Density |
10.8 + /- .1 lb/ gal |
pH |
>9.0 + 0.5 |
Viscosity |
115 - 120 KU |
Tensile Strength
ASTM D2370
|
240 psi |
Elongation
ASTM D2370
|
400% |
Permanence
ASTM D1653A
|
24 perms |
Water Swelling
ASTM D471
|
24% |
Accl. Weathering
ASTM D4798
|
No cracking or splitting |
Wet Adhesion
ASTM C794
|
3.0 pli (concrete) |
Dry Adhesion
ASTM C794
|
9.0 pli (concrete) |
Fungi Resistance
ASTM G21
|
Passes |
Low Temp. Flex.
ASTM D522
|
Passes |
Vehicle/ solvent |
Water |
iDry time to re-coat |
24 Hours |
V.O.C 50 grams per liter |
| |
| Water |
CAS# 7732-18-5 |
| Titanium |
CAS# 13463-67-7 |
| Calcium Carbonate |
CAS# 1317-65-3 |
| Zinc Oxide |
CAS# 1314-13-2 |
| Ceramic |
CAS# 65997-17-3 |
| Acrylic Resin |
Trade Secret |
| Emergency Telephone: INFOTRAC - (800)535-5053 |
|
|
